FAPT LADDER EPROM READER/WRITER CONVERTER:
When you write eprom or read eprom for discompile in normally you have to use FANUC eprom w/r for PMC-L/M/P.
Now you can use converter software to finish jobs of
fanuc eprom w/r. And you can choice any general (or commercial) eprom
w/r to finish these jobs. It need not specially transformer (220V/100V)
as like as fa-writer.
Normally fanuc eprom w/r writing speed is 50ms/ per byte. Now new type eprom w/r much fast than traditional. Because traditional writing speed is fix 50ms but now normally use compare method.So when you use new way to do these jobs you will feel more faster than before.
Now you have two choices:
1. For retrofit cnc to write eprom you can use #ex--->oe1,oe2 files converte function.. The two files are used for writing eprom. The *.#ex is produced by compile function in fladder (F3 key). The .#ex file is fixed length 75360 bytes.
2. if you have eprom and want to look ladder drawing
you can use oe1,oe2 ---->#ex function. The *.#ex file is
used for discompile through function(F4 key). The oe1 and oe2 are also fixed file
length 32768 bytes.
* General (commercial ) EPROM w/r is prepared by client. You can buy any
type of eprom writer/reader in the market.
